PrimeLab 1.0 MULTITEST, Руководство пользователя

Страница: 160 / 353

127 127
Continued...
Liquid
(30)
Iron (HR)
0 - 30 mg/l
2+/3+
(Fe )
8) Add 10 drops "PL Iron HR 1" liquid reagent to the water sample in the
cuvette.
9) Replace the lid on the cuvette, swirl it carefully and insert it into the
sampling chamber of the PrimeLab. Align the arrow on the front of the
cuvette. Press TEST.
10) After the lapse of a 5 minute countdown the determined result is
displayed. Press button 4 to save this together with date and time in the
device.
4
4
B) Measurement procedure for “total iron”
1) Fill 10ml unfiltered sample water into a clean 24mm cuvette.
2) Replace the screw lid on the cuvette and insert it into the PrimeLab
sampling chamber. Align the arrow on the front of the cuvette. Press
ZERO.
3) Remove the cuvette from the chamber and unscrew the lid.
4) Add 2 drops "PL Iron HR 2" liquid reagent to the test liquid in the
cuvette.
5) Replace the lid on the cuvette, swirl it carefully and insert it into the
sampling chamber of the PrimeLab. Align the arrow on the front of the
cuvette. Press TEST.
6) Wait for the lapse of a 2 minute countdown.
7) Remove the cuvette from the chamber and unscrew the lid.
Continued...
4
4
Name on device: 30-Iron-HR-liq
!
Possible messages in the line below the measurement value:
"low! / high! / good!":
Assessment of the measurement value relative to the ideal range defined by you.
"Overrange! / underrange!":
Measurement value for this parameter is outside the value range of this method.
One-Time-Zero:
Measure new ZERO
Use last ZERO
For the sake of precision select "Use last ZERO" only
if the stored ZERO value is used with the
same cuvette and the same water sample for the test!
!
If after switching on the device you have already performed the
ZERO (baseline) adjustment for the same type, the following
message is displayed:
-> Measure new ZERO = continue with step 2)
-> Use last ZERO = continue with step 4)
1 2 3 4