PrimeLab 1.0 MULTITEST, Руководство пользователя

Страница: 207 / 353

174 174
(152)
Nitrogen-Total (HR)
5 - 150 mg/l (N)
Name on device: 152-NitroTotHR-pre
16mm vial
18) Proceed to next step to intitiate next countdown.
19) Reagents need to react press TEST to start 02:00 minutes countdown.
20) Open 1 Acid LR/HR vial(s) and add 2ml from ZERO vial to one.
This is your new ZERO vial.
21) Add 2ml from former TEST vial to second new vial. This is your new
SAMPLE vial.
22) Cap both cells and shake to mix. CAUTION: heat build-up!
23) Place the 16mm adaptor into the device.
25) Place the ZERO cell and the light protection cover and than press
ZERO.
26) Remove the cell from the device.
27) Place the sample cell and the light protection cover into the device.
Than press TEST.
B) Only ZERO and TEST:
1) Place the 16mm adaptor into the device.
2) Place the ZERO cell and the light protection cover and than press
ZERO.
3) Remove the cell from the device.
4) Place the sample cell and the light protection cover into the device.
Than press TEST.
Continued...
One-Time-Zero:
Measure new ZERO
Use last ZERO
For the sake of precision select "Use last ZERO" only
if the stored ZERO value is used with the
same cuvette and the same water sample for the test!
!
If after switching on the device you have already performed the
ZERO (baseline) adjustment for the same type, the following
message is displayed:
-> Measure new ZERO = continue with step 22)
-> Use last ZERO = continue with step 25)
1 2 3 4
4
4
Continued...
4
4
4