PrimeLab 1.0 MULTITEST, Руководство пользователя

Страница: 119 / 353

86 86
(163)
Dissolved Oxygen
1.) Fill a cleaned cell (24mm) with 10 ml of your sample.
2.) Close the lid, place the cell into the photometer (use caution to the
arrow on the cell) and press ZERO.
3.) Remove the cell and open the lid.
4.) Empty the cell. Clean careful the cell and the lid.
5.) Fill a 50ml glass bottle with the water you want to test up to the top.
6.) Apply the stopper (exceeding water will leak out).
7.) Remove the stopper.
8.) Add 5 drops “PL DissOx 1" into the glass bottle.
9.) Apply the stopper.
10.) Gently shake glass bottle for 01:00 minute.
11.) Press TEST to start 01:00 minute countdown.
12.) Remove the stopper.
13.) Add 5 drops “PL DissOx 2" into the glass bottle.
4
10 ml
24 mm
Liquid
The individual steps of the measurement procedure are shown on the display.
Use button 3 (arrow down) to scroll through the steps.
Use button 4 to skip the notes.
!
Measurement procedure:
The steps up to the selection of the parameter value to be determined are the same for all
procedures and described on page "TEST-5".
Please observe the important notes for
accurate measurements on pages "TEST-8" and "TEST-9".
One-Time-Zero:
Measure new ZERO
Use last ZERO
For the sake of precision select "Use last ZERO" only
if the stored ZERO value is used with the
same cuvette and the same water sample for the test!
!
If after switching on the device you have already performed the
ZERO (baseline) adjustment for the same type, the following
message is displayed:
-> Measure new ZERO = continue with step 2)
-> Use last ZERO = continue with step 4)
1 2 3 4
Continued...
PL DissOx 1
(PL30DO1)
PL DissOx 2
(PL30DO2)
PL DissOx
3 (PL30DO3)
0 - 10 mg/l (O )
2
Name on device: 163-DissOxyg-liq
4