Oki BV1250, Руководство по установке

Страница: 149 / 344

Oki BV1250 Installation Guide PHYSICAL INSTALLATION
Revision 1.0 Page 139 of 334
4.2.3 Line Interface Board Kit
The Base Unit must be accompanied by one of the following Line Interface
kits. The type of kit will vary based on the network application.
All installations require one of the Line Interface Board Kits described
below.
49
Analog Kit
The Analog (AP/FXS) kit may be either the BS1200-AP kit or the
BV1250-FXS kit. Both of these kits allow direct connection to an
analog circuit (telephone and/or fax) or with the Loop Start Trunks of
a PBX or Key Telephone System. In general, the following
components should be present.
Table 4-1: Analog Line Interface Board Kits
Kit Type Kit Contents Connector Type Pinouts
BS1200-AP
•
Interface Board
•
Cable connectors
•
Screws
•
Labeling materials
•
Packing List
1 - Tip
2 - Ring
BV1250-FXS
•
Interface Board
•
Screws
•
Labeling materials
•
Packing List
1 - not used
2 - Tip
3 - Ring
4 - not used
FXO Kit
The FXO kit may be either the BS1200-FXO or the BV1250-FXO kit.
Both of these kits allow direct connection to PSTN and/or PBX
system through an analog type interface. In general, the following
components should be present.
Table 4-2: FXO Line Interface Board Kits
Kit Type Kit Contents Connector Type Pinouts
BS1200-FXO
•
Interface Board
•
Cable connectors
•
Screws
•
Labeling materials
•
Packing List
1 - Tip
2 - Ring
BV1250-FXO
•
Interface Board
•
Screws
•
Labeling materials
•
Packing List
1 - not used
2 - Tip
3 - Ring
4 - not used
49
Kit tables also include connector types and pin assignments. See Section 4.5.3 for a discussion of
cable preparation.