Oki BV1250, Руководство по установке

Страница: 181 / 344

Oki BV1250 Installation Guide PHYSICAL INSTALLATION
Revision 1.0 Page 171 of 334
4.8 Power-Up the BV1250 and Verify Operation
Once all connections have been made, the BV1250 can be set to its power-ON
condition. Once the unit is powered-up, power should only be returned to the
power-OFF state for installation or hardware maintenance activities.
Also, during the power-up process, several state indicators can be viewed to assure
that the unit is operating properly.
To turn the BV1250 power on:
1. Check that all cables are properly connected.
2. Locate the power switch at the rear of the unit and toggle the switch to the ON
position.
Figure 4-35 : Power switch and front panel indicators
To verify proper operation, observe the following during the POWER ON
process.
When the power switch is toggled to the ON position, check for the
following indications:
•
Power, Online, Alarm, and Busy lamps light up during the initialization
process.
•
The Alarm and Busy lamps turn off following initialization and the
Power and Online lamps remain lit.
If the Alarm and/or Busy lamps remain lit for more than five minutes, turn
the unit power OFF and contact an authorized Oki representative.
A blinking alarm lamp indicates that the built-in clock battery has
been discharged and the time parameter is no longer synchronized.
This can occur if the unit is left without power for more than two
months. This condition will cease once the clock is recharged and
reset. This generally takes about 10 minutes. See Section 5.11 for
the Maintenance Console Software clock reset procedure.
IF the BV1250 is connected to the ethernet network, the "Link" lamp
will also light up.