NSK MEGATORQUE M-ESB-YSB2020AB300, Руководство пользователя

Страница: 82 / 356

— 3-9 —
B B 3 3 t t y y p p e e B B 5 5 t t y y p p e e
2 2 3 3 t t y y p p e e 2 2 5 5 t t y y p p e e
3.3. Wiring
3.3.5. Wiring of Conector
3.3.5. Wiring of Connector
！
Caution: • Be sure to install a serge killer circuit when inductive switches, such as
relays, are used.
！
Caution: • When you install sensors such as “Home position limit switch,”
“+ direction sensor of over travel limit switch” and “- direction of over
travel limit switch,” connect output of those sensors directly, not via the
controller. (Those outputs are shown as
in Figure 3-6 below.)
3.3.5.1. Example of B3 and 23 Driver Units (CN2)
Type 1 (TY1): Selection of sixteen internal program channels
Figure 3-7
Polarity of the power supply may
be reversed to minus common.
Servo on
Emergency stop
Home position limit switch
Start positioning
Internal program•channel selection 0
Internal program•channel selection 1
Internal program•channel selection 2
Internal program•channel selection 3
Driver Unit ready
Positioning completed
Brake/Veocity threshold/Proximity•In target/Over
13 DC24
25 SVON
12 EMST
11 HLS
24 RUN
9 PRG0
22 PRG1
10 PRG2
23 PRG3
15 DRDY+
2 DRDY-
14 IPOS
3 OUT1 *1
1 COM
FG
User’s controller ESB Driver Unit
CN2
24 VDC
24 VDC
l
Home Return
à
For an example, write HS command to channel CH0 and then;
à
Select the CH0 to start the Home Return (RUN input ON) after turning on the power
and complete the Home Return.
l
Pulse train command operation
à
When control the System by the pulse train input command, add connections to CWP ±
and CCWP ± signals.
*1: The parameter OM selects one of outputs from among BRK (Brake), SPD (Velocity
threshold), NEARA (Near proximity/In target), and OVER (Warning) for OUT1. The
shipping set is BRK.