NSK MEGATORQUE M-ESB-YSB2020AB300, Руководство пользователя

Страница: 233 / 356

— 8-4 —
B B 3 3 t t y y p p e e B B 5 5 t t y y p p e e
8. Glossary of Command and Parameter
2 2 3 3 t t y y p p e e 2 2 5 5 t t y y p p e e
For ESBB5 and 25type Driver Units only
AL: Acceleration Limiter
Format : AL data
Data range : 0, and 0.01 to 1 280.00 [s
-2
]
Shipping : 0
Default : 0
l
This command sets the limits on acceleration/deceleration caused by changes of velocity
command in the velocity control mode.
l
This parameter is applicable to the velocity command of both analog command input and the
RS-232C communication command.
l
Setting AL0 disables the function of limiting acceleration/deceleration.
l
For more details, refer to “6.3.3.Function to Limit Acceleration / Deceleration.”
l
The TS or ?AL command reports the current setting.
«
AN: Axis Number
Format : AN data
Data range : 0 to 15
Shipping set : 0
Default : 0
l
Sets the axis number to each Driver Unit in the daisy chain communication mode.
l
The TS command or ?AN command reports the current setting.
l
Refer to “7.3.4. Daisy Chain Communication.”
For B3 and B5 type Driver Units only
«
AO: Absolute Position Scale Offset
Format : AO data
Data range : 0 to 819 199 [pulse]
Shipping set : 0
Default : 0
l
Sets the offset value between the Motor absolute position scale and the user absolute position
scale.
l
AO data = (Motor absolute position data) – (user absolute position data)
l
AO data will be reset if the user absolute position scale is cleared by the AZ command.
l
The TS or ?AO command reports the current setting.