NSK MEGATORQUE M-ESB-YSB2020AB300, Руководство пользователя

Страница: 301 / 356

— 10-2 —
B B 3 3 t t y y p p e e B B 5 5 t t y y p p e e
10.1. Identifying Alarm
10.1.2. Using TA Command
2 2 3 3 t t y y p p e e 2 2 5 5 t t y y p p e e
10.1.2. Using TA Command
TA: Tell Alarm Status
Format : TA ENT
l
The TA command reports an alarm status.
l
The same contents of alarm identification, which is indicated on the 7-segment LED on the front
panel, will be displayed on the screen.
l
However, the readout is not indicated in time-sharing like the LED.
*Example:
Excess position error and heat sink overheat alarms
:TA
F1>Excess Position Error
P0>Over Heat
:_
F1: Excessive position error alarm
P0: Heat sink overheat alarm
[Example 1] Identify an alarm as the warning lamp of ALARM is on.
(1) Confirm that the display of Handy Terminal shows the colon “: .”
(If the colon “:” is not shown in the display, press the ENTER key once.)
:_
(2) Input the TA command.
:TA_
A T
(3) Press the ENT key and the display identifies the alarm.
:TA
F1>Excess Position Error
:_
ENT
l
Thus the alarm is identified as “Excess position error.”