Nidek Medical ICE-1000, Руководство оператора

Страница: 61 / 116

51
OPERATING PROCEDURES : Setting Processing Conditions and Entering Layout Data
2
Select either of the following.
5
Enter the height of the eye point.
Pressing the numeric button next to the PD or BT button displays the numeric keypad.
Enter any value and press the Ent button.
6
When blocking the lens with Mark mode, enter the EP value.
Pressing the numeric button next to the EP button displays the numeric keypad. Enter any
value and press the Ent button.
The range of the EP value is 0.0 to +6.0 mm in increments of 0.1 mm.
As soon as the EP value has been entered,
the eye point mark for far vision changes as
shown in the figure.
7
Select the layout mode between active (ACT) and passive (PAS).
Pressing the Passive (or Active) button changes the setting.
PD
Enter the distance between the
eye point for far vision and
straight down point of the lens
shape.
BT
Enter the distance between the
eye point for far vision and the
lowest point of the lens shape.
ÐÄ
ÂÔ
• The Prog. EP input parameter allows the operator to choose whether to enter EP values for
each individual JOB data or to use the displayed EP value for blocking with Mark mode.
It is strongly recommended to set the Progressive. EP input parameter to Necessary to avoid
omitting a modification to EP values when it is necessary to change the EP values for each indi-
vidual JOB data. See “4.1 Setting Parameters” (Page 89) for the details on the setting method.
• The EP value serves in the same manner as with Full-auto mode and with Semi-auto mode.
It is allowed to shift the eye point mark for far vision as shown in the above figure for easy align-
ment. In Full-auto or Semi-auto mode, enter a desired EP value because the value has no effect
on layout and blocking.
ÅÐ