Nidek Medical ICE-1000, Руководство оператора

Страница: 11 / 116

1
1
1.
BEFORE USE
1.1 Outline of the Instrument
NIDEK Intelligent blocker, ICE-1000 blocks the lens with a lens cup. The lens is blocked with a lens
cup properly at a detected position (the optical center, cylinder axis angle, segment position of bifocal
lenses, and marking). This ICE-1000 has the following features:
• The built-in tracing unit allows efficient processing of lenses, from tracing through blocking.
• The ICE-1000 is equipped with the Auto Lensmeter (ALM)
*1
function. This function allows
the operator to block a single vision lens without marking the optical center of the lens,
which was necessary with previous lensmeters.
• Blocking of the lens with the lens cup is performed with the optimum blocking pressure with
a simple button operation.
• The motorized alignment function in the X-, Y- and
θ
-axis directions allows the operator to
accurately block the lens simply by placing the lens at the approximate center of the lens
table.
• An uncut lens outline obtained by the built-in CMOS camera and the lens shape image
obtained by the built-in tracing unit are displayed simultaneously on the LCD screen. This
diameter verification of the uncut lens allows the operator to check if the uncut lens diame-
ter is sufficient for the lens shape prior to processing. Then the operator can proceed with
blocking.
• Switching between active and passive modes can be performed easily by button operation
without moving the lens.
•The high resolution CMOS camera facilitating blocking by providing clear images of the
printed eye point for far vision of the progressive power lenses or lens markings.
*1. The Auto Lensmeter (ALM) function is for obtaining the optical center and cylinder axis required for blocking. Do not use
this function for measuring lenses since it is different from a lensmeter.