Nidek Medical ICE-1000, Руководство оператора

Страница: 103 / 116

93
CONNECTION AND SETTINGS : Setting Parameters
4
16) Slot coordinate mode: Center, Edge
Factory setting: Center
Selects the reference points either from
center or edge when entering the coordi-
nates of slotted holes or the distance
between the hole and notch.
[Parameter description: Parameter 3 screen]
17) Layout preset: –5.0 to 5.0mm
Factory setting: 2.0 mm
This parameter sets the default of the height of the optical center. Set any value from –5.0 to
5.0mm (in increments of 0.1 mm).
18) Optical center height input: Necessary, Unnecessary
Factory setting: Necessary
This parameter sets whether the height of the optical center value should be fixed or not
when the ICE-1000 imports traced data on condition that the ICE-1000 displays no layout
data on the screen.
When the parameter is set to Necessary, it is necessary to modify the height of the optical
center value after traced data is imported from a tracer (the corresponding button is dis-
played in yellow).
When the parameter is set to Unnecessary, it is unnecessary to modify the height of the opti-
cal center value (the corresponding button is displayed in green).
19) Prog. EP input: Necessary, Unnecessary
Factory setting: Necessary
This parameter sets whether or not to let the operator confirm an EP value when entering
layout data for progressive power lenses with Point Mark mode.
Center Edge