Mocom millennium B, Руководство по обслуживанию, Страница: 73 / 285

Rev. 1
Page 2-
5
SELECTING THE STERILIZATION PROGRAM
Program selection is fundamental for a successful sterilization process.
Since each instrument, or material in general, has different shape, consistency and properties, it is important
to identify the most suitable
program for it , both for preserving its physical characteristics (avoiding or, at any rate, limiting alterations) as well to guarantee the most effective
sterilization.
Power-on the device.
e
If a password has been enabled with the option ANY POWER ON or ANY CYCLE START (see Setting the Password ), you will be
asked to enter the access code:
I N S E R T P A S S W O R D
↵ t o e n t e r
t o e x i t
Enter the password using the + and – keys. Confirm with the
↵
key.
The display does not offer any active preselection. The device is waiting for the user to select a program.
Press the
PROGRAM SELECTION key one or more times until you reach the desired program (1, 2, 3 or 4, also shown on the upper left of the
display).
e
When the selection key is pressed, the first sterilization program proposed is the one used for the last cycle executed .
In the two lines above the description, the display shows the description of the selected program and the type of drying set and, below, the set-
point values for the temperature
(°C ), pressure ( bar ) and time ( mm:ss ) of the cycle selected. By way of example, the display shows.
1
1 3 4 ° C P O R O U S
N O R M A L D R Y I N G
1 3 4 . 0 ° C ( B )
2 . 1 0 b a r 0 4 : 0 0