Mocom millennium B, Руководство по обслуживанию, Страница: 101 / 285

Rev. 1
Page 2-
33
e
If a password has been set with the ANY CYCLE START option (see chapter Setting the Password ), you will be asked to enter the
access code.
I N S E R T P A S S W O R D
↵ t o e n t e r
t o e x i t
In addition, the equipment checks the printer paper presence and, if MILLFLASH is connected, the presence of the Compact Flash card and its
memory capacity. The possible warning messages, and the consequent actions to carry out, are the same as described for a standard
sterilization cycle.
The vacuum phase begins immediately and the display reads:
V A C U U M T E S T
V A C U U M P U L S E
- 0 . 6 9 b a r 0 1 : 0 2
The display shows the pressure (
bar ), and the total time from the start of the program.
When the pre-set pressure is reached (
-0.80 bar) the pump stops and the pressure stabilization phase begins ( WAITING PERIOD ), which lasts 5
minutes (shown on the display as a scalar value):
V A C U U M T E S T
W A I T I N G P E R I O D
0 5 : 0 0
- 0 . 8 0 b a r 0 1 : 4 8
During this phase, a variation of the maximum low pressure is allowed of
not more than 10% , without this causing the test to fail .