Mocom millennium B, Руководство по обслуживанию, Страница: 63 / 285

Rev.1
Page 1-
59
MAINTENANCE
GENERAL
For better quality maintenance, supplement ordinary checks with regular periodic examinations by the service department ( see Appendix Z ).
It is also fundamental to perform a
periodic sterilizer validation , i.e., a check of the thermodynamic parameters of the process, comparing them
with the reference values provided with suitably calibrated instruments.
e
Refer to the paragraph Periodic sterilizer validation .
The ordinary maintenance described below consists in easy manual operations and preventive interventions involving simple instruments.
I
N THE EVENT OF THE REPLACEMENT OF THE DEVICE
'
S COMPONENTS OR PARTS
,
REQUEST AND
/
OR USE
ORIGINAL REPLACEMENT PARTS
ONLY
.
ORDINARY MAINTENANCE PROGRAM
Maintenance schedule
The table summarizes the maintenance required to keep the sterilizer operating at peak efficiency. In the case of
very intense use , we
recommend shortening maintenance intervals:
DAILY
Clean the gasket and the porthole
Clean external surfaces
Cleaning of the gasket and do
Cleaning of the external s
WEEKLY Clean the sterilization chamber and relative accessories
Disinfect external surfaces
Cleaning of the sterilization chambe
Disinfection of the externa
MONTLY
Clean the internal (and external - if installed) distilled water tank
Safety valve maintenance
Clean (or replace) the water drain filter
ƒ
Lubrication of the door locking mechanism
ƒ
Maintenance of the safety valve
ƒ
Cleaning (or replacement) of the draining
ƒ
Sterilization of the bacteriologic filter
EVERY 3/6 MONTHS
(depending on the frequency of
use)
Replace bacteriological filter
ƒ
Replacement of the bacteriologic filter
ANNUALLY Validate sterilizer
ƒ
Validation of the sterilizer