Minebea Intec CSD-918 Series, Руководство по эксплуатации

Страница: 64 / 240

Note:
-
Conirm the setting (refer to Chapter 7.3.5 ) before moving the gate by manual
operation.
According to the set value, there is a possibility of movement diferent from the
direction that the gate intended.
- The command pulse value (output) is displayed in the display part of [INTERNAL
COUNTER].
The encoder pulse value (input) of 4 multiplications is displayed in the display part
of [EXTERNAL COUNTER].
7.5.1 Switch to calibration screen of manual speed
Proceed as follows to switch from the weighing screen to the manual speed calibration
screen.
7.5.2 Low speed Calibration (LOW SPEED CALIB.)
Execute the calibration of a low speed in manual operation. A low speed calibration in
manual operation is used for ine adjustment when the calibration of the gate position is
executed. Calibrate at the speed of a possible locating.
The calibration range is 0.001 min
-1
to calibration value at high speed.
0.01 min
-1
is set as default.
Note:
Conirm the setting (refer to Chapter 7.3.5 ) before moving the gate by manual operation.
According to the set value, there is a possibility of movement diferent from the
direction that the gate intended.
7.5.3 High speed calibration (HIGH SPEED CALIB.)
Execute the calibration of a high speed in manual operation.
A high speed calibration in manual operation is used for coarse adjustment when the
calibration of the gate position is executed.
The calibration range is 0.001 min
-1
to rated motor rotation value [min
-1
].
20.000 min
-1
is set as default.
1. Select [MENU].
2. Select [MANUAL SPEED CALIB.] in the screen of menu screen 1/2.
3. Select [MANUAL SPEED CALIB.] in servo calibration screen.
1. Select [LOW SPEED CALIB.] in the screen of manual speed calibration.
2. Select [LOW SPEED] at low speed calibration screen.
3. Input rotation value (min
-1
) of the servo motor in low speed movement with ten key.
4. Tap [OK].
5. Tap [OPEN] or [CLOSE], and conirm the speed of the gate in the movement of gate
OPEN or gate CLOSE.
6. Tap [OK].
Weight Controller CSD-918 7 Servo calibration
EN-62 Minebea Intec