Minebea Intec CSD-918 Series, Руководство по эксплуатации

Страница: 48 / 240

6.4.2 Fine calibration of zero and SPAN
Status of ZERO adjustment / SPAN adjustment
6.4.2.1 Zero calibration
After the condition with no load applied on the weighing section.
(By pressing them continuously, increment can be provided continuously.)
After the calibration of zero point.
6.4.2.2 SPAN calibration
(By pressing them continuously, increment can be provided continuously.)
After the adjustment of span point
6.5 Registration and conirmation of pitch (PITCH CONFIRMATION)
This is a function to register up to 6 points of A/D count rate in an arbitrary point during
the calibration of zero and SPAN, and to conirm the load indicated value of each pitch in
the point registered after the calibration of SPAN.
1. Select [ZERO POINT ADJUSTMENT] on ine calibration screen.
A present weighing value with 1/10 digit (DIVISION) is displayed.
2. Please calibrate the display to zero by using the increase ↑ and the decrease ↓.
3. Tap [OK] to return to weighing screen.
1. Select [SPAN POINT ADJUSTMENT] on ine calibration screen.
2. Apply the calibration weight which can be put on the load cell and also less than the
max. load (Max).
The display becomes the present weighing value with the 1/10 digit (DIVISION).
3. Adjust the displayed value by using the increase ↑ and the decrease ↓ to become the
same weight value applied on the weighing section.
4. Tap [OK] to return to weighing screen.
Weight Controller CSD-918 6 Calibration
EN-46 Minebea Intec