Starting up the device - Basic configuration
Leuze electronic GmbH + Co. KG
CML 730i
71
The structure of these configurations in the receiver control panel menu is as follows (multiple configura
-
tions displayed simultaneously):
Examples
Configuration of pin 2 as PNP switching output
The following example shows a configuration of pin 2 as PNP switching output with additional configura
-
tions, such as area logic “OR” with a beam area of 1 … 32 and beam 1 as start beam according to the
following table.
Select Digital IOs > IO Logic > Positive PNP.
Select Digital IOs > IO Pin 2 > IO Function > Area Output.
Select Digital IOs > IO Pin 2 > Inversion > Inverted.
Select Digital IOs > IO Pin 2 > Area logic > OR.
Select Digital IOs > IO Pin 2 > Start Beam > 001.
Select Digital IOs > IO Pin 2 > End Beam > 032.
Configuration of pin 2 as PNP warning output
The following example shows the configuration of pin 2 as PNP warning output.
The individual configuration steps for the extended configuration combinations are not described
separately.
When configuring start and end beam, you can configure values of up to 1774. Values above
1774 (to 1999) are not accepted and must be entered again.
OR
Start beam
1
End beam
32
Switch-on condition
1 beam interrupted
Switch-off condition
0 beams interrupted
Level 0
Level 1
Level 2
Description
Digital IOs
IO Logic
Positive PNP
Negative NPN
IO Pin 2
IO Function
Trigger In
Teach In
Area Out
Warn Out
Trigger Out
Inversion
Normal
Inverted
Teach height
Execute
Exit
Area logic
AND
OR
Start Beam
001
End Beam
032
Level 0
Level 1
Level 2
Description
Digital IOs
IO Logic
Positive PNP
Negative NPN
IO Pin 2
IO Function
Trigger In
Teach In
Area Out
Warn Out
Trigger Out
Inversion
Normal
Inverted
Teach height
Execute
Exit
