DS2 Docking Station
Version 9.1
(P/N: 17112798)
INDUSTRIAL SCIENTIFIC
iii
Warnings and Cautionary Statements
WARNING:
Failure to perform certain procedures or note certain conditions may impair the
performance of this product. For maximum safety and optimal performance, please read and
follow the procedures and conditions listed below.
Use of this product in areas where it may be subject to large amounts of electromagnetic
interference may affect the reliable operation of this device and should be avoided.
Sources of large amounts of interference could be and are not limited to:
o
Operation near high radio frequency fields (near 2-way radio
transmission antennas where the RF fields may greatly exceed
10 V/M, etc.).
o
AC Power Mains that may have excessive power surges / spikes /
transients (from large AC motors operating heavy loads which may
induce voltage sags and, etc.).
NOTE:
This product has been tested to, and passes all EMC requirements to EN 61326:1998
Electrical Equipment for Measurement, Control and Laboratory Use for Type 2 (Industrial)
Apparatus, as well as FCC Part 15, Class A emissions levels when installed to the requirements
outlined within this manual. Mandatory compliance to these standards help to ensure controlled,
reliable operation of this device when exposed to typical levels of electromagnetic interference
as well as ensuring that this device is not source of emissions that might interfere with other
equipment installed nearby.
NOTE:
Per 30 CFR 75.320(b), the DS2 Docking Station tests for oxygen deficiency of MSHA
approved oxygen detectors compatible with the DS2 Docking Station that can detect 19.5 percent
oxygen with an accuracy of ±0.5 percent.
NOTE:
The DS2 has an internal pump that controls the flow of gas being delivered to the
system. As a result of the internal pump, a demand flow regulator must be used in conjunction
with this calibration and bump test station.
