IBM PC Server 520, Руководство пользователя

Страница: 281 / 438

Removing Internal Drives
Attention: Before you hot-swap a drive, make sure it is defective.
If you partially or completely remove a good drive instead of a
defective one, your server might lose valuable data.
Thoroughly review the information displayed on your server
monitor to determine the location of the failed drive.
If you partially or completely remove a good drive instead of the
defective one, your server might lose valuable data. This situation
is especially relevant if your server is a disk-array model and you
assigned RAID level 1 or 5 to the logical drives in your disk array.
However, the RAID controller can rebuild the data you need,
provided that certain conditions are met. See “Starting the
ServeRAID Configuration Program” on page 80 for further details.
To remove a drive from bank C, D, or E, do the following steps:
1. Find the defective drive you plan to remove.
2. Ensure that you have selected the correct drive for removal by
verifying that the light on the tray's knob is blinking or not
illuminated.
Attention: Before you hot-swap a drive, make sure it is
defective. If you partially or completely remove a good drive
instead of a defective one, your server might lose valuable data.
3. Press the power-off switch on the drive tray. When the green
LED begins to blink, it is safe to remove the drive.
4. Unlock the drive by turning the knob clockwise 90 degrees.
Unlocked
Position
Chapter 6. Installing Options
265