HNC Electric HV610C Series, Руководство пользователя

Страница: 108 / 176

Section V. Parameter Function Table
95
Fb.05
Setup length
0m~65535m 1000m
☆
Fb.06
Actual length
0m~65535m 0m
☆
Fb.07 Pulse number per meter
0.1~6553.5
100.0
☆
The three parameters such as setup length, actual length and number of pulses per meter are mainly
used for fixed-length control.
Length information needs to be collected through multi-function digit input terminal,you can get Fb.06
actual length by division of terminal sampling pulse number and Fb.06.When actual length is longer than
reference length Fb.05,multi-function digit terminal DO output “length arrival” ON signal.
During the process of fixed-length control,length reset operation(by multi-function terminal DI)is
permitted(choose DI function selection as 28),for specifications please refer to F4.00~F4.09.
Set corresponded input terminal function to “length counting input”(function 27).When pulse frequency
is high,only X5 port can be used.
Fb.08 Counting value setup
1~65535 1000
☆
Fb.09 Designated counting value
1~65535 1000
☆
Counting value should be collected through multi-function digital input terminal. Corresponding input
terminal should be set to the function of “counter input”(function 25) in application. X5 terminal should be
used when pulse frequency is high.
When counting value reaches Fb.08 set value, multi-function digit DO output “setup counting value
arrival” ON signal, then stop counting.
When counting value reaches Fb.09 set value, multi-function digit DO output “designatedcounting
value arrival”ON signal, then continues to count until reaching “setup counting value”.
Specified counting value should not be greater than setup counting value Fb.08.
1 2 3 4 5 6 7 8 9
Pulse counting
DI5
Set counting
DO1
Designated counting
relay
Fig.5-29 Setup counting value&designated counting value schematic diagram