HNC Electric HV610C Series, Руководство пользователя

Страница: 53 / 176

Section V. Parameter Function Table
40
1
：
Memory
Digital setup frequency is the retention that reserved at last stop time. Keyboard “
∧
”
、
“
∨
” or
terminal UP
、
DOWN to make the correction valid.
F0.24
Motor selection
Motor 1
0
0
★
Motor 2
1
HV610C support applications that driving 2 motors in time-sharing. 2 motors can be set motor
nameplate parameters, independent parameter tuning, control mode, parameters relating to operation
performance respectively.
Motor 1 corresponding function groups are F1 group and F2 group. Motor 2 corresponding groups
are A2 group
Users select current motor through F0.24 function code as well as digital input terminal DI. When
function code selection conflicting with terminal DI selection, DI terminal selection is priority.
F0.25
Acceleration / deceleration
reference frequency
Maximum frequency(F0.10)
0
0
★ Set frequency
1
100Hz
2
Acceleration / deceleration time means the time needed for the inverter varying from 0Hz to the
frequency ofF0.25, Fig5.1 is acceleration / deceleration time schematic diagram.
When F0.25 is choosen to 1, acceleration / deceleration time is connected with set frequency.If set
frequency change frequently, the motor acceleration willchange,attention should be paid in applications.
F0.26
Frequency UP/DOWN
reference upon running
Running frequency
0
0
★
Set frequency
1
This parameter is only valid when frequency source is digital setting.
To select(through keyboard
∧ 、 ∨
key or terminal UP/DOWN) the modifying method of set
frequency, namely, target frequency is increasing/decreasing based on the running frequency or setting
frequency.
The difference between the two settings become apparently in inverter acceleration and
deceleration process.
F0.27
Command source &
frequency source binding
1bit
Operation panel command bound
frequency source selection
000
☆
Without binding
0
Digital setup frequency source
1
AI1
2
AI2
3
AI3
4
PULSE pulse setup(X5)
5
MS command
6
Simple PLC
7
PID
8
Communication setup
9
10bit
Terminal command bound frequency
source selection
Without bound
0