GSK 980MDc, Руководство пользователя

Страница: 300 / 473

Chapter 10 Document Management
281
Ⅱ
Operation
Method 2: Press address key key in parameter No., then press key
4
）
Press and hold key for 2 seconds or press key to skip to a bit of the parameter,
and the bit is backlighted. Press or key to move the cursor to the bit to be altered, then
key in 0 or 1
5
）
After all parameters setting is finished, the PARM SWT needs to be set for OFF for security
Note: After entering a bit of the parameter, press
key to skip out of the bit and back to the parameter No.
Example:
Set the BIT5 (DECZ) of the bit parameter No.004 to 1, and the other bits unchanged Move the cursor to
“No.004” by the steps above, press key to skip to a bit of the parameter, the figure is shown below:
Move the cursor to “BIT5” by pressing or key, the figure is shown below:
Key in “1” to finish the alteration.