GSK 980MDc, Руководство пользователя

Страница: 286 / 473

Chapter 7 Auto Operation
267
Ⅱ
Operation
CHAPTER 7 AUTO OPERATION
7.1 Auto Run
7.1.1 Selection of a Program To Be Run
1. Search method
1
）
Select the Edit or Auto mode;
2
）
Press key to enter the PRG CONTENT page;
3
）
Press the address key and key in the program No.
4
）
Press
or
key, the program retrieved will be shown on the screen, if the program
doesn’t exist, the system prompts the required file does not exist at the bottom of the CNC.
5 ) Press , the program retrieved will be shown on the screen, if the program doesn’t exist, the
system prompts “PROGRAM DOES NOT EXIST”.
Note: In step 4, if the program to be retrieved does not exist, a new program will be setup by CNC system after
pressing key.
2. Scanning method
1
）
Select the Edit or Auto mode
2
）
Press key to enter the PRG display page
3
）
Press the address key
4
）
Press the or key to display the next or previous program;
5
）
Repeat the step 3, 4 above to display the saved program one by one.
3. File open method
Select the edit or operation mode:
1
）
Press key twice to enter the page of file list.
；
2
）
Press
，
keys to move the cursor to the file will be selected.
3 ） Press key to select a file.
Note
！
The keys functions of this GSK980MDc machine panel are defined by Ladder;
please refer to the respective materials by the machine builder for the function
significance.
Please note that the following function introduction is described based on the
GSK980MDc standard PLC programs!