Fuji Electric ALPHA5 Smart, Руководство пользователя

Страница: 196 / 636

CHAPTER 4 PARAMETER
4-28
Control Gain and Filter Setting Parameter
4
Control mode
No.
PA1_
Name
Default
value
Power
Position Speed Torque
Record of
reference value
84
Vibration suppressing anti resonance frequency 3
300.0 -  - -
85
Vibration suppressing workpiece inertia ratio
(vibration suppressing resonance frequency) 3
0 -  - -
86
Vibration suppressing damping coefficient
0.0000 -  - -
87
Model torque filter time constant
*** -   -
88
Position loop integration time constant
*** -  - -
89
Position loop integration limiter
0 -  - -
90
Load torque observer
0 -   -
91
P/PI automatic change selection
0 -   -
92
Speed range for friction compensation
10.0 -
 
-
93
Coulomb friction torque for friction compensation
0 -
 
-
94
Torque filter setting mode
1 -   -
95
Model torque calculation selection, speed observer
selection
3 -   -
96
Speed limit gain for torque control
4.0 - - -

Paremeters marked "
○
" in the table are enabled in the corresponding control mode.
4.3.2 Description of Each Parameter
PA1_51 to 53 Command filter settings
No. Name Setting range
Default
value
Change
51 Moving average S-curve time 0, 2 to 500 (×0.125 [ms]) *** Always
52
Low-pass filter (for S-curve) time
constant 0.0 to 1000.0 [ms]
0.0 Always
53 Command pulse smoothing function 0: Disable 1: Enable 0 Always
Filters can be added to commands for smoother follow-up.
Moving
average
S-curve time
This parameter is enabled under position control.
Specify the moving average S-curve filter time to position commands.
A larger setting at low command pulse frequencies or large electronic gear ratios can
reduce the torque ripple caused by fluctuation of the command pulse.
The new setting of this parameter is reflected when both the position command and
filter accumulation pulse are "0".
If PA1_13 (tuning mode selection) is 10 (auto tuning), 11 (semi-auto tuning) or
15(shorter cycle time operation mode) automatic adjustment is made inside the
amplifier.
Low-pass
filter (for
S-curve)
time constant Enter the low-pass filter (for S-curve) filter time constant in relation to position
commands and speed commands. Acceleration and deceleration are made so that an
approximate S-curve is drawn.
Command
pulse
smoothing
function
The parameter is enabled under position control.
If the function is enabled, smoothing is added to the position command every 2 ms
intervals.
A larger setting at low command pulse frequencies or large electronic gear ratios can
reduce the torque ripple caused by fluctuation of the command pulse.
While the setting can be changed at any time, the new setting is reflected when both
the position command and filter accumulation pulse are "0".