The OneCommand Utility User Manual
Page 171
Value1 - Parameter Value.
Value2 - Boot Device Entry Number: {0 - 7}.
CEE Commands
CEEDownload
Supported by: Windows, Solaris SFS, Linux and VMware ESX Server
Syntax: hbacmd CEEDownload <WWPN> <Filename>
Description: Updates the CEE firmware on the adapter.
Parameters:
WWPN - World Wide Port Name of the adapter.
Filename - Name of the file to download.
GetCEEParams
Supported by: Windows, Solaris SFS, Linux and VMware ESX Server
Syntax: hbacmd GetCEEParams <WWPN | MAC>
Description: Shows the Internal Host PFC flag value and DCBX mode (i.e. CEE version). For CNAs
(both iSCSI and FCoE) Priorities, Priority Groups, and the corresponding bandwidths are shown. The
LLDP state is also displayed.
Parameters:
WWPN - World Wide Port Name of the FCoE adapter port.
MAC - MAC address of the NIC or iSCSI port.
SetCEEParam
Supported by: Windows, Solaris SFS, Linux and VMware ESX Server
Syntax: hbacmd SetCEEParam <WWPN | MAC> <Param> <Value>
Description: Set or clear the Internal Host PFC flag. SetCEEParam configures one of the CEE
parameters. The values must be set according to the following rules:
1.
For FCoEPriority and iSCSIPriority the valid range is 0 to 7.
A single priority must be specified.
2.
PFCPriorities are specified by a single priority or a list of comma separated values.
The valid range for each priority is 0 to 7.
3.
For the following parameters, the valid values are 0 and 1:
Note: Converged Enhanced Ethernet (CEE) commands are for CEE management of
LP21000 series and OneConnect adapters only.
Note: CEE commands are not supported for NIC only adapters.
Note: Supported for LP21000 series adapters only. Not supported for OneConnect
adapters.
