The OneCommand Utility User Manual
Page 144
During the export process, progress is displayed in the lower right hand side of the progress bar.
On Windows, you cannot change views, reset, or download firmware during the export process.
Diagnostics
Fibre Channel Diagnostics
This section describes the diagnostics for non-OneConnect adapters. For OneConnect adapters, See
“iSCSI, FCoE and NIC-Only Diagnostics (OneConnect Adapters Only)” on page 153.
Use the Diagnostics tab to do the following:
•
View flash load list, PCI registers and wakeup parameter information.
•
Run these tests on Emulex adapter's installed in the system: (Not available in read-only mode.)
•
PCI Loopback (see page 149)
•
Internal Loopback (see page 149)
•
External Loopback (see page 149)
•
Power-On Self Test (POST) (see page 147)
•
Echo (End-to-End) (see page 151)
•
Quick Test (see page 146)
•
Perform a diagnostic dump (see page 147) (Not available in read-only mode.)
•
Control adapter beaconing (see page 147) (Not available in read-only mode.)
All functions are supported locally and remotely on hosts managed with TCP/IP access.
Note: All diagnostic tests and diagnostic dumps can only be performed on the local system
or on remote systems connected with TCP/IP access. Diagnostic tests and diagnostic
dumps cannot be performed on remote systems connected with FC access.
Note: Not supported on systems using CIM provider v1.2.1 on ESX 3i. and only partially
supported on systems using CIM provider v2.0 on ESX 4i.
Note: Quick Test, POST Test, and the Advanced Diagnostic Test buttons are disabled for
any remote adapter that is managed in-band.
Note: Diagnostics are not supported on COMSTAR ports.
