The OneCommand Utility User Manual
Page 142
EFIBoot Advanced Adapter Settings dialog box
Use the EFIBoot Advanced Adapter Settings dialog box to configure the advanced settings for the
selected EFIBoot adapter.
Figure 81: EFIBoot Advanced Adapter Settings dialog box
EFIBoot Advanced Adapter Settings Field Definitions
•
Device Path - Makes the Fibre driver appear as a SCSI driver.
•
Fibre (default)
•
SCSI
•
Boot Target Scan - This option is available only if none of the eight boot entries are configured to
boot via DID or WWPN.
•
NVRAM Targets (default) - Discovers only LUNs that are saved to the adapter Non-Vol-
atile Random Access Memory (NVRAM).
•
Discovered Targets - Discovers all devices that are attached to the FC port. Discovery
can take a long time on large SANs.
•
None
•
EFIBootFCScanLevel: NVRAM Targets and EFIBootFCScanLevel: Discovered Targets -
Allows 3rd party software to toggle between Boot Path from NVRAM and Boot Path from
Discovered Targets by manipulating an EFI system NVRAM variable.
•
Maximum LUNs per Target - Sets the maximum number of LUNs that are polled during device
discovery. The range is 1 to 4096. The default is 256.
•
Reset Delay Timer in seconds - Sets a value for delay device discovery. The range is 0 to 255.
The default is 0.
•
PLOGI Retry Timer - Sets the interval for the PLOGI (port log in) retry timer. This option is
especially useful for Tachyon-based RAID arrays. Under very rare occasions, a Tachyon-based
RAID array resets itself and the port goes offline temporarily in the loop. When the port comes
online again the PLOGI retry interval scans the loop to discover this device.
