Dell S6000-ON, Руководство по настройке

Страница: 94 / 1080

to be authenticated, but still need access to the network. Also, some dumb-terminals, such as network
printers, do not have 802.1X capability and therefore cannot authenticate themselves. To be able to
connect such devices, they must be allowed access the network without compromising network security.
The Guest VLAN 802.1X extension addresses this limitation with regard to non-802.1X capable devices
and the Authentication-fail VLAN 802.1X extension addresses this limitation with regard to external users.
• If the supplicant fails authentication a specified number of times, the authenticator places the port in
the Authentication-fail VLAN.
• If a port is already forwarding on the Guest VLAN when 802.1X is enabled, the port is moved out of
the Guest VLAN and the authentication process begins.
Configuring a Guest VLAN
If the supplicant does not respond within a determined amount of time ([reauth-max + 1] * tx-period, the
system assumes that the host does not have 802.1X capability and the port is placed in the Guest VLAN.
NOTE: For more information about configuring timeouts, refer to Configuring Timeouts .
Configure a port to be placed in the Guest VLAN after failing to respond within the timeout period using
the
dot1x guest-vlan
command from INTERFACE mode. View your configuration using the
show
config
command from INTERFACE mode or using the
show dot1x interface
command from EXEC
Privilege mode.
Example of Viewing Guest VLAN Configuration
Dell(conf-if-Te-2/1/1)#dot1x guest-vlan 200
Dell(conf-if-Te 2/1/1))#show config
!
interface TenGigabitEthernet 2/1/1
switchport
dot1x guest-vlan 200
no shutdown
Dell(conf-if-Te 2/1/1))#
Configuring an Authentication-Fail VLAN
If the supplicant fails authentication, the authenticator re-attempts to authenticate after a specified
amount of time.
NOTE: For more information about authenticator re-attempts, refer to Configuring a Quiet Period
after a Failed Authentication .
You can configure the maximum number of times the authenticator re-attempts authentication after a
failure (
3 by default), after which the port is placed in the Authentication-fail VLAN.
Configure a port to be placed in the VLAN after failing the authentication process as specified number of
times using the
dot1x auth-fail-vlan
command from INTERFACE mode. Configure the maximum
number of authentication attempts by the authenticator using the keyword
max-attempts
with this
command.
Example of Configuring Maximum Authentication Attempts
Dell(conf-if-Te-2/1/1)#dot1x guest-vlan 200
Dell(conf-if-Te 2/1)#show config
!
interface TenGigabitEthernet 2/1/1
switchport
dot1x authentication
94
802.1X