Dell S6000-ON, Руководство по настройке

Страница: 662 / 1080

configure multiple recursive routes in a redirect list by entering multiple
seq redirect
commands
with the same source and destination address and specify a different next-hop IP address. In this
way, the recursive routes are used as different forwarding routes for dynamic failover. If the primary
path goes down and the recursive route is removed from the routing table, the
seq redirect
command is ignored and the next command in the list with a different route is used.
Apply a Redirect-list to an Interface using a Redirect-group
IP redirect lists are supported on physical interfaces as well as virtual local area network (VLAN) and port-
channel interfaces.
NOTE: When you apply a redirect-list on a port-channel, when traffic is redirected to the next hop
and the destination port-channel is shut down, the traffic is dropped. However, the traffic redirected
to the destination port-channel is sometimes switched.
To apply a redirect list to an interface, use the following command. You can apply multiple redirect-lists
can be applied to a redirect-group. It is also possible to create two or more redirect-groups on one
interface for backup purposes.
Apply a redirect list (policy-based routing) to an interface.
INTERFACE mode
ip redirect-group redirect-list-name
•
redirect-list-name
is the name of a redirect list to apply to this interface.
• FORMAT: up to 16 characters
To delete the redirect list from this interface, use the
no ip redirect-group
command.
In this example, the list
xyz
is applied to the tenGigabitEthernet 2/1/1 interface.
Example: Applying a Redirect-list to an Interface
Dell(conf-if-te-2/1/1)#ip redirect-group xyz
Dell(conf-if-te-2/1/1)#
Example: Applying a Redirect-list to an Interface
Dell(conf-if-te-1/1/1)#ip redirect-group test
Dell(conf-if-te-1/1/1)#ip redirect-group xyz
Dell(conf-if-te-1/1/1)#show config
!
interface TenGigabitEthernet 1/1/1
no ip address
ip redirect-group test
ip redirect-group xyz
shutdown
Dell(conf-if-te-1/1/1)#
In addition to supporting multiple redirect-lists in a redirect-group, multiple redirect-groups are
supported on a single interface. Dell Networking OS has the capability to support multiple groups on
an interface for backup purposes.
Show Redirect List Configuration
To view the configuration redirect list configuration, use the following commands.
1. View the redirect list configuration and the associated interfaces.
662
Policy-based Routing (PBR)