Dell S6000-ON, Руководство по настройке

Страница: 121 / 1080

ACL Resequencing
ACL resequencing allows you to re-number the rules and remarks in an access or prefix list.
The placement of rules within the list is critical because packets are matched against rules in sequential
order. To order new rules using the current numbering scheme, use resequencing whenever there is no
opportunity.
For example, the following table contains some rules that are numbered in increments of 1. You cannot
place new rules between these packets, so apply resequencing to create numbering space, as shown in
the second table. In the same example, apply resequencing if more than two rules must be placed
between rules 7 and 10.
You can resequence IPv4 and IPv6 ACLs, prefixes, and MAC ACLs. No CAM writes happen as a result of
resequencing, so there is no packet loss; the behavior is similar Hot-lock ACLs.
NOTE: ACL resequencing does not affect the rules, remarks, or order in which they are applied.
Resequencing merely renumbers the rules so that you can place new rules within the list as needed.
Table 7. ACL Resequencing
Rules Resquencing
Rules Before Resequencing: seq 5 permit any host 1.1.1.1
seq 6 permit any host 1.1.1.2
seq 7 permit any host 1.1.1.3
seq 10 permit any host 1.1.1.4
Rules After Resequencing: seq 5 permit any host 1.1.1.1
seq 10 permit any host 1.1.1.2
seq 15 permit any host 1.1.1.3
seq 20 permit any host 1.1.1.4
Resequencing an ACL or Prefix List
Resequencing is available for IPv4 and IPv6 ACLs, prefix lists, and MAC ACLs.
To resequence an ACL or prefix list, use the following commands. You must specify the list name, starting
number, and increment when using these commands.
• IPv4, IPv6, or MAC ACL
EXEC mode
resequence access-list {ipv4 | ipv6 | mac} { access-list-name StartingSeqNum
Step-to-Increment }
• IPv4 or IPv6 prefix-list
EXEC mode
resequence prefix-list {ipv4 | ipv6} { prefix-list-name StartingSeqNum Step-
to-Increment }
Access Control Lists (ACLs)
121