Dell S6000-ON, Руководство по настройке

Страница: 386 / 1080

To view the Primary RPM Management port, use the
show interface Managementethernet
command in EXEC Privilege mode. If there are two RPMs, you cannot view information on that interface.
Configuring a Management Interface on an Ethernet Port
You can manage the system through any port using remote access such as Telnet.
To configure an IP address for the port, use the following commands. There is no separate management
routing table, so configure all routes in the IP routing table (the
ip route
command).
• Configure an IP address.
INTERFACE mode
ip address
• Enable the interface.
INTERFACE mode
no shutdown
• The interface is the management interface.
INTEFACE mode
description
Example of the
show interface
and
show ip route
Commands
To display the configuration for a given port, use the
show interface
command in EXEC Privilege
mode, as shown in the following example. To display the routing table, use the
show ip route
command in EXEC Privilege mode.
Dell#show int TenGigabitEthernet 1/1/1
TenGigabitEthernet 1/1/1 is up, line protocol is up
Description: This is the Managment Interface
Hardware is Force10Eth, address is 00:01:e8:cc:cc:ce
Current address is 00:01:e8:cc:cc:ce
Pluggable media not present
Interface index is 46449666
Internet address is 10.11.131.240/23
[output omitted]
Dell#show ip route
Codes: C - connected, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
> - non-active route, + - summary route
Gateway of last resort is 10.11.131.254 to network 0.0.0.0
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
*S 0.0.0.0/0 via 10.11.131.254, Te 1/1/1 1/0 1d2h
C 10.11.130.0/23 Direct, Te 1/1/1 0/0 1d2h
Dell#
386
Interfaces