Dell S6000-ON, Руководство по настройке

Страница: 788 / 1080

debug
Remote Authentication
The system takes the access class from the server. Access class is the class of service that
restricts Telnet access and packet sizes.
If you have configured remote authorization, the system ignores the access class you have configured for
the VTY line and gets this access class information from the server. The system must know the
username and password of the incoming user before it can fetch the access class from the server. A user,
therefore, at least sees the login prompt. If the access class denies the connection, the system closes the
Telnet session immediately. The following example demonstrates how to configure the access-class
from a server. This configuration ignores the configured access-class on the VTY line. If you
have configured a deny10 ACL on the server, the system downloads it and applies it. If the user
is found to be coming from the 10.0.0.0 subnet, the system also immediately closes the Telnet
connection. Note, that no matter where the user is coming from, they see the login prompt.
When configuring a server host, you can set different communication parameters, such as the
key password.
Example of Specifying a Server Host
Dell(conf)#
Dell(conf)#aaa authentication login tacacsmethod
Dell(conf)#aaa authentication exec tacacsauthorization
Dell(conf)#tacacs-server host 25.1.1.2 key Force
Dell(conf)#
Dell(conf)#line vty 0 9
Dell(config-line-vty)#login authentication tacacsmethod
Dell(config-line-vty)#end
Specifying a Server Host
To specify a server host and configure its communication parameters, use the following
command.
• Enter the host name or IP address of the server host.
CONFIGURATION mode
tacacs-server host { hostname | ip-address } [port port-number ] [timeout
seconds ] [key key ]
Configure the optional communication parameters for the specific host:
–
port port-number
: the range is from 0 to 65535. Enter a TCP port number. The default is 49 .
–
timeout seconds
: the range is from 0 to 1000. Default is 10 seconds .
–
key key
: enter a string for the key. The key can be up to 42 characters long. This key must match
a key configured on the server host. This parameter must be the last parameter you
configure.
If you do not configure these optional parameters, the default global values are applied.
Example of Connecting with a Server Host
To specify multiple server hosts, configure the
tacacs-server host
command multiple
times. If you configure multiple server hosts, Dell Networking OS attempts to connect with
them in the order in which they were configured.
788
Security