Dell S6000-ON, Руководство по настройке

Страница: 634 / 1080

–
seconds
: the range is from 1 to 65535 (the default is 1 second ).
The transmit delay must be the same on all routers in the OSPF network.
Example of Changing and Verifying the
cost
Parameter and Viewing Interface Status
To view interface configurations, use the
show config
command in CONFIGURATION INTERFACE
mode.
To view interface status in the OSPF process, use the
show ip ospf interface
command in EXEC
mode.
The bold lines in the example show the change on the interface. The change is reflected in the OSPF
configuration.
Dell(conf-if)# ip ospf cost 45
Dell(conf-if)#show config
!
interface TenGigabitEthernet 1/1/1
ip address 10.1.2.100 255.255.255.0
no shutdown
ip ospf cost 45
Dell(conf-if)#end
Dell#show ip ospf 34 interface
TenGigabitEthernet 1/1/1 is up, line protocol is up
Internet Address 10.1.2.100/24, Area 2.2.2.2
Process ID 34, Router ID 10.1.2.100, Network Type BROADCAST, Cost: 45
Transmit Delay is 1 sec, State DR, Priority 1
Designated Router (ID) 10.1.2.100, Interface address 10.1.2.100
Backup Designated Router (ID) 10.1.2.100, Interface address 0.0.0.0
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:06
Neighbor Count is 0, Adjacent neighbor count is 0
Dell#
Enabling OSPFv2 Authentication
To enable or change various OSPF authentication parameters, use the following commands.
• Set a clear text authentication scheme on the interface.
CONFIG-INTERFACE mode
ip ospf authentication-key key
Configure a
key
that is a text string no longer than eight characters.
All neighboring routers must share password to exchange OSPF information.
• Set the authentication change wait time in seconds between 0 and 300 for the interface.
CONFIG-INTERFACE mode
ip ospf auth-change-wait-time seconds
This setting is the amount of time OSPF has available to change its interface authentication type.
When you configure the
auth-change-wait-time
, OSPF sends out only the old authentication
scheme until the wait timer expires. After the wait timer expires, OSPF sends only the new
authentication scheme. However, the new authentication scheme does not take effect immediately
634
Open Shortest Path First (OSPFv2 and OSPFv3)