Dell S6000-ON, Руководство по настройке

Страница: 882 / 1080

• You cannot enable root guard and loop guard at the same time on an STP port. For example, if you
configure loop guard on a port on which root guard is already configured, the following error
message is displayed:
% Error: RootGuard is configured. Cannot configure LoopGuard
.
• Enabling Portfast BPDU guard and loop guard at the same time on a port results in a port that remains
in a blocking state and prevents traffic from flowing through it. For example, when Portfast BPDU
guard and loop guard are both configured:
– If a BPDU is received from a remote device, BPDU guard places the port in an Err-Disabled
Blocking state and no traffic is forwarded on the port.
– If no BPDU is received from a remote device, loop guard places the port in a Loop-Inconsistent
Blocking state and no traffic is forwarded on the port.
• When used in a PVST+ network, STP loop guard is performed per-port or per-port channel at a VLAN
level. If no BPDUs are received on a VLAN interface, the port or port-channel transitions to a Loop-
Inconsistent (Blocking) state only for this VLAN.
To enable a loop guard on an STP-enabled port or port-channel interface, use the following command.
• Enable loop guard on a port or port-channel interface.
INTERFACE mode or INTERFACE PORT-CHANNEL mode
spanning-tree {0 | mstp | rstp | pvst} loopguard
–
0
: enables loop guard on an STP-enabled port assigned to instance 0.
–
mstp
: enables loop guard on an MSTP-enabled port.
–
rstp
: enables loop guard on an RSTP-enabled port.
–
pvst
: enables loop guard on a PVST-enabled port.
To disable STP loop guard on a port or port-channel interface, use the
no spanning-tree 0
loopguard
command in an INTERFACE configuration mode.
To verify the STP loop guard configuration on a port or port-channel interface, use the
show spanning-
tree 0 guard [interface interface ]
command in a global configuration mode.
Displaying STP Guard Configuration
To display the STP guard configuration, use the following command.
The following example shows an STP network (instance 0) in which:
• Root guard is enabled on a port that is in a root-inconsistent state.
• Loop guard is enabled on a port that is in a listening state.
• BPDU guard is enabled on a port that is shut down (Error Disabled state) after receiving a BPDU.
• Verify the STP guard configured on port or port-channel interfaces.
show spanning-tree 0 guard [interface interface ]
Example of Viewing STP Guard Configuration
Dell#show spanning-tree 0 guard
Interface
Name Instance Sts Guard type
--------- -------- --------- ----------
Te 1/1/1 0 INCON(Root) Rootguard
Te 1/2/1 0 LIS Loopguard
Te 1/3/1 0 EDS (Shut) Bpduguard
882
Spanning Tree Protocol (STP)