![background image](http://html.mh-extra.com/html/cisco/sce-1000-and/sce-1000-and_configuration-manual_64496072.webp)
3-10
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 3 Operations
Managing Application Files
The following commands are relevant for installing and uninstalling an application:
•
pqi install file
(interface linecard configuration mode)
•
pqi uninstall file
(interface linecard configuration mode)
•
pqi upgrade file
(interface linecard configuration mode)
•
pqi rollback file
(interface linecard configuration mode)
•
show pqi file info
(viewer mode)
•
show pqi last-installed
(viewer mode)
How to Display Information about an Application File
Step 1
From the SCE> prompt, type
show pqi file filename info
and press
Enter
.
Displays installation options available for this application file, if any.
How to Install an Application
Step 1
From the SCE(config if)# prompt, type
pqi install file
filename
[options]
and press
Enter
.
Installs the specified pqi file, using the installation options specified (if any). Use the
show pqi file
filename info
command to display installation options available for the application file. (See
How to
Display Information about an Application File, page 3-10
.)
Note that this may take up to five minutes.
Note
Always run the
pqi uninstall
command before installing a new pqi file. (See
How to Uninstall an
Application, page 3-10
.)
How to Uninstall an Application
Step 1
From the SCE(config if)# prompt, type
pqi uninstall file
filename
and press
Enter
.
Uninstalls the specified pqi file.
You must specify the last pqi file that was installed.
Note that this may take up to five minutes.