![background image](http://html.mh-extra.com/html/cisco/sce-1000-and/sce-1000-and_configuration-manual_64496149.webp)
5-55
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 5 Configuring the Management Interface and Security
IP Configuration
Options
The following options are available:
•
prefix
— IP address of the routing entry, in dotted notation.
•
mask
— The relevant subnet mask, in dotted notation
Step 1
From the SCE# prompt, type
show ip route
prefix mask
and press
Enter
.
Displays the routing table for the specified subnet (prefix/mask).
Displaying the IP Routing Table for a Specified Subnet: Example
This example shows how to display the routing table for a specified subnet.
SCE#show ip route 10.1.60.0 255.255.255.0
| prefix | mask | next hop |
|-----------------|-----------------|-----------------|
| 10.1.60.0 | 255.255.255.0 | 10.1.1.5 |
sce#
IP Advertising
•
Configuring IP Advertising, page 5-55
•
How to Display the Current IP Advertising Configuration, page 5-56
IP advertising is the act of periodically sending ping requests to a configured address at configured
intervals. This maintains the SCE platform IP/MAC addresses in the memory of adaptive network
elements, such as switches, even during a long period of inactivity.
The following commands are relevant to IP advertising:
•
[no] ip advertising
•
ip advertising destination
•
ip advertising interval
•
default ip advertising destination
•
default ip advertising interval
•
show ip advertising
•
show ip advertising destination
•
show ip advertising interval
Configuring IP Advertising
To configure IP advertising, you must first enable IP advertising. You may then specify a destination
address to which the ping request is to be sent and/or the frequency of the ping requests (interval). If no
destination or interval is explicitly configured, the default values are assumed.