![background image](http://html.mh-extra.com/html/cisco/sce-1000-and/sce-1000-and_configuration-manual_64496127.webp)
5-33
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 5 Configuring the Management Interface and Security
Configuring and Managing the SNMP Interface
Enabling the SNMP Interface
Use this command to enable the SNMP interface. For more information on configuring and managing
the SNMP parameters, including hosts, communities, contact, location, and trap destination hosts, see
Configuring and Managing the SNMP Interface, page 5-33
.
•
How to Enable the SNMP Interface, page 5-33
•
How to Disable the SNMP Interface, page 5-33
How to Enable the SNMP Interface
Options
The following options are available:
•
community-string
— a security string that identifies a community of managers who are permitted
to access the SNMP server
Step 1
From the SCE(config)# prompt, type
snmp-server community
community-string
and press
Enter
.
You must define at least one community string to allow SNMP access. For complete information on
community strings see
Configuring SNMP Community Strings, page 5-42
.
How to Disable the SNMP Interface
Step 1
From the SCE(config)# prompt, type
no snmp-server
and press
Enter
.
Configuring and Managing the SNMP Interface
•
Information About the SNMP Interface, page 5-33
•
Configuring SNMP Community Strings, page 5-42
•
Configuring SNMP Notifications, page 5-43
Information About the SNMP Interface
This section explains how to configure the SNMP agent parameters. It also provides a brief overview of
SNMP notifications and the supported MIBs, and explains the order in which the MIB must be loaded.