![background image](http://html.mh-extra.com/html/cisco/sce-1000-and/sce-1000-and_configuration-manual_64496165.webp)
5-71
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 5 Configuring the Management Interface and Security
Configuring the Management Port Physical Parameters
How to Configure the Duplex Operation of the Management Interface
•
Options, page 5-71
•
Configuring the Duplex Operation of the Management Interface: Example, page 5-71
Options
The following options are available:
•
duplex
— duplex operation of the currently selected management port (0/1 or 0/2):
–
full
–
half
–
auto
(default) — auto-negotiation (do not force duplex on the link)
If the speed parameter is configured to
auto,
changing the
duplex
parameter has no effect (see ).
Step 1
From the SCE(config if)# prompt, type
duplex
auto|full|half
and press
Enter
.
Configures the duplex operation of the currently selected management interface.
Configuring the Duplex Operation of the Management Interface: Example
The following example shows how to use this command to configure both management ports to half
duplex mode.
SCE#config
SCE(config)#interface mng 0/1
SCE(config if)#duplex half
SCE(config if)#exit
SCE(config)#interface mng 0/2
SCE(config if)#duplex half
How to Configure the Speed of the Management Interface
•
Options, page 5-71
•
Configuring the Speed of the Management Interface: Example, page 5-72
Options
The following options are available:
•
speed
— speed in Mbps of the currently selected management port (0/1 or 0/2):
–
10
–
100
–
auto
(default) — auto-negotiation (do not force speed on the link)
If the duplex parameter is configured to
auto,
changing the
speed
parameter has no effect (see ).
Step 1
From the SCE(config if)# prompt, type
speed
10|100|auto
and press
Enter
.
Configures the speed of the currently selected management interface.