![background image](http://html.mh-extra.com/html/cisco/sce-1000-and/sce-1000-and_configuration-manual_64496281.webp)
10-11
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 10 Redundancy and Fail-Over
CLI Commands for Cascaded Systems
Examples
EXAMPLE 1
Use the following command to configure the primary SCE platform in a two-SCE platform inline
topology. Link 1 is connected to this SCE platform and the behavior of the SCE platform if a failure
occurs is
bypass.
SCE 2000(config if)#connection-mode inline-cascade physically-connected-links link-1
priority primary on-failure bypass
EXAMPLE 2
Use the following command to configure the SCE platform that might be cascaded with the SCE
platform in Example 1. This SCE platform would have to be the secondary SCE platform, and Link 0
would be connected to this SCE platform, since Link 1 was connected to the primary. The connection
mode would be the same as the first, and the behavior of the SCE platform if a failure occurs is also
bypass.
SCE 2000(config if)# connection-mode inline-cascade physically-connected-links link-0
priority secondary on-failure bypass
Monitoring a Cascaded System
Use the following commands to view the current connection mode and link mode parameters.
•
How to View the Current Connection Mode, page 10-11
•
How to View the Current Link Mode, page 10-11
•
How to View Current Link Mappings, page 10-11
How to View the Current Connection Mode
Step 1
From the SCE 2000> prompt, type
show interface linecard 0 connection-mode
and press
Enter
.
How to View the Current Link Mode
Step 1
From the SCE 2000> prompt, type
show interface linecard 0 link mode
and press
Enter
.
How to View Current Link Mappings
Step 1
From the SCE 2000> prompt, type
show interface linecard 0 physically-connected-links
and
press
Enter
.