![background image](http://html.mh-extra.com/html/cisco/sce-1000-and/sce-1000-and_configuration-manual_64496140.webp)
5-46
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 5 Configuring the Management Interface and Security
Managing Passwords
How to Enable the SNMP Server to Send Authentication Failure Notifications
Step 1
At the SCE(config)# prompt, type
snmp-server enable traps snmp authentication
and press
Enter
.
How to Enable the SNMP Server to Send All Enterprise Notifications
Step 1
At the SCE(config)# prompt, type
snmp-server enable traps enterprise
and press
Enter
.
How to Enable the SNMP Server to Send a specific Enterprise Notification
Step 1
At the SCE(config)# prompt, type
snmp-server enable traps enterprise
[attack|chassis|link-bypass|logger|operational-status|port-operational-status|pull-request-failure|RDR
-formatter|session| SNTP|subscriber|system-reset|telnet|vas-traffic-forwarding]
and press
Enter
.
Specify the desired enterprise trap type.
Enabling the SNMP Server to Send a Specific Enterprise Notification: Example
The following example shows how to configure the SNMP server to send the logger enterprise
notification only.
SCE(config)#snmp-server enable traps enterprise logger
How to Restore All Notifications to the Default Status
Step 1
At the SCE(config)# prompt, type
default snmp-server enable traps
and press
Enter
.
Resets all notifications supported by the SCE platform to their default status.
Managing Passwords
•
About Passwords, page 5-47
•
Changing Your Password, page 5-47
•
Password Encryption, page 5-49
•
Password Recovery, page 5-49