5-5
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 5 Configuring the Management Interface and Security
Configuring the Management Port Physical Parameters
Configuring the Management Interface Speed and Duplex Parameters
This section presents sample procedures that describe how to configure the speed and the duplex of the
Management Interface.
Both these parameters must be configured separately for each port.
•
Interface State Relationship to Speed and Duplex, page 5-5
•
How to Configure the Speed of the Management Interface, page 5-5
•
How to Configure the Duplex Operation of the Management Interface, page 5-6
Interface State Relationship to Speed and Duplex
Table 5-1
summarizes the relationship between the interface state and speed and duplex.
How to Configure the Speed of the Management Interface
•
Options, page 5-5
•
Configuring the Speed of the Management Interface: Example, page 5-6
Options
The following options are available:
•
speed
— speed in Mbps of the currently selected management port (0/1 or 0/2):
–
10
–
100
–
auto
(default) — auto-negotiation (do not force speed on the link)
If the duplex parameter is configured to
auto,
changing the speed parameter has no effect (see ).
Step 1
From the SCE(config if)# prompt, type
speed 10|100|auto
and press
Enter
.
Specify the desired speed option.
Table 5-1
Interface State Relationship to Speed and Duplex
Speed
Duplex
Actual FE Interface State
Auto
Auto
Auto negotiation
Auto
Full
Auto negotiation
Auto
Half
Auto negotiation
10
Auto
Auto-negotiation (duplex only)
10
Full
10 Mbps and full duplex
10
Half
10 Mbps and half duplex
100
Auto
Auto-negotiation (speed only)
100
Full
100 Mbps and full duplex
100
Half
100 Mbps and half duplex