![background image](http://html.mh-extra.com/html/cisco/sce-1000-and/sce-1000-and_configuration-manual_64496265.webp)
9-37
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 9 Managing Subscribers
Configuring the Actual Maximum Number of Subscribers
How to Display All Subscribers Mapped to a Specified IP Range
Step 1
From the SCE> prompt, type
show interface linecard 0subscriber mapping included-in
TP-IP-range
ip-address/mask
and press
Enter
.
How to Display the Number of Subscribers Mapped to a Specified IP Range
Step 1
From the SCE> prompt, type
show interface linecard 0 subscriber amount mapping included-in
TP-IP-range
ip-address/mask
and press
Enter
.
Configuring the Actual Maximum Number of Subscribers
The actual maximum number of subscribers supported is based on the capacity option specified when
loading the SCA BB application. If no capacity option is specified, the user-configured default capacity
is used. However, you can override this capacity option using the following commands.
Note the following:
•
You must configure the override before you load the application. The configured maximum number
of subscribers takes effect when the next load command is executed.
•
If you have disabled the capacity option and then the next time you load a new application you want
to use the capacity option, you must re-enable the capacity option before loading the application file
(see
How to Restore the Configured Capacity Option, page 9-38
).
•
Use the
show
subscriber max-subscribers
command to see what the current maximum number of
subscribers is and whether the capacity option is enabled or disabled (see
How to Monitor the
Maximum Number of Subscribers, page 9-38
.)
How to Override the Configured Capacity Option
The default maximum number of subscribers is 80K.
Step 1
Select the maximum number of subscribers:
From the SCE(config if)# prompt, type
subscriber max-subscribers (40K | 80K | 120K | 200K)
and
press
Enter
.
Step 2
:Disable the application capacity option:
From the SCE(config if)# prompt, type
subscriber capacity-options disable
and press
Enter
.
Step 3
Install the new application file. (The configured subscriber maximum takes effect only after a new
application file has been loaded.)