![background image](http://html.mh-extra.com/html/cisco/sce-1000-and/sce-1000-and_configuration-manual_64496333.webp)
12-19
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
OL-7827-12
Chapter 12 Value Added Services (VAS) Traffic Forwarding
Configuring VAS Traffic Forwarding
Step 1
From the SCA BB console, remove all the VAS table associations to packages and apply the changed
policy.
Step 2
From the SCE(config if)# prompt, type
shutdown
and press
Enter
.
Shuts down the line card.
Step 3
From the SCE(config if)# prompt, type
no VAS-traffic-forwarding
and press
Enter
.
Disables VAS traffic forwarding.
Step 4
From the SCE(config if)# prompt, type
no shutdown
and press
Enter
.
Re-enables the line card.
How to Configure the VAS Traffic Link
•
Options, page 12-19
•
How to Select the Link for VAS Traffic, page 12-19
•
How to Revert to the Default Link for VAS Traffic, page 12-19
By default, the VAS traffic is transmitted on Link 1. If the VAS servers are connected on Link 0, you
must configure the VAS traffic link to Link 0.
To configure the link for VAS over 10G, see
VAS over 10G, page 12-32
).
Note
The VAS traffic link should be in Forwarding mode.
Options
The following option is available:
•
VAS traffic-link {link-0|link-1}
— The link number on which to transmit VAS traffic
–
Default — Link 1
How to Select the Link for VAS Traffic
Step 1
From the SCE(config if)# prompt, type
VAS-traffic-forwarding traffic-link {link-0|link-1}
and press
Enter
.
How to Revert to the Default Link for VAS Traffic
Step 1
From the SCE(config if)# prompt, type
no VAS-traffic-forwarding traffic-link
and press
Enter
.