Cisco Catalyst 3560-E Series, Руководство по эксплуатации

Страница: 42 / 150

2-24
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
OL-9772-05
Chapter 2 Message and Recovery Procedures
DOT1X_SWITCH Messages
Error Message
DOT1X-5-SUCCESS: Authentication successful for client ([chars]) on
Interface [chars] AuditSessionID [chars]
Explanation
Authentication was successful. The first [chars] is the client ID, the second [chars] is
the interface, and the third [chars] is the session ID.
Recommended Action
No action is required
DOT1X_SWITCH Messages
Error Message
DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address [enet] on
[chars] AuditSessionID [chars]
Explanation The client MAC address could not be added to the MAC address table because the
hardware memory is full or because the address is a secure address on another port. [enet] is the
client MAC address, the first [chars] is the interface, and the second [chars] is the session ID.
Recommended Action If the hardware memory is full, remove some of the dynamic MAC addresses.
If the client address is on another port, remove it from that port.
Note This message applies to switches running the IP base image.
Error Message
DOT1X_SWITCH-5-ERR_INVALID_PRIMARY_VLAN: Attempt to assign primary
VLAN [dec] to 802.1x port [chars] AuditSessionID [chars]
Explanation
An attempt was made to assign a primary VLAN to an 802.1x port, which is not allowed.
[dec] is the VLAN, the first [chars] is the port, and the second [chars] is the session ID.
Recommended Action
Use a different VLAN.
Note
This message applies to switches running the IP base image.
Error Message
DOT1X_SWITCH-5-ERR_INVALID_SEC_VLAN: Attempt to assign invalid
secondary VLAN [dec] to PVLAN host 802.1x port [chars] AuditSessionID [chars]
Explanation
An attempt was made to assign a nonsecondary VLAN to a private VLAN host 802.1x
port. [dec] is the VLAN, the first [chars] is the port, and the second [chars] is the session ID.
Recommended Action
Change the port mode so that it is no longer a private VLAN host port, or use
a valid secondary VLAN.
Note
This message applies to switches running the IP base image.