Chevrolet 1977 10 Series, Руководство по ремонту, Страница: 58 / 468

3B-16
OVERHAUL MANUAL
Fig. 3 B -4 1--Removing B e a rin g and Seal Fig. 3 B - 4 3 —I n s ta ll in g A d j u s t e r Plug Seal
bottom ed on the stub shaft assembly. V a |v e g n d
^
s h a f t A s s e m b |y
3. Install retaining ring with Internal Pliers J-4245.
4. Lubricate the thrust bearing assembly with Power
Steering Fluid. Place the flanged thrust bearing race on the
adjuster plug hub, then install the thrust bearing, small
bearing race (flanged side up) and spacer (grooves of spacer
away from bearing).
5. Install a new bearing retainer on the adjuster plug by
carefully tapping on the flat surface of the retainer (fig. 3B-
44).
NOTE:
The projections m ust not extend beyond the
spacer when the retainer is sealed to prevent interference
with the valve body. The spacer m ust be free to rotate.
Fig. 3B -42--lnstalling Bearing
J-70 79-2
Disassembly
1. Remove and discard the "O" ring in the shaft cap end
of the valve assembly.
2. To remove the lower shaft assembly from the valve
body, proceed as follows:
a. While holding the assembly (stub shaft down), lightly
tap the stub shaft against the bench until the shaft cap is free
from the valve body (fig. 3B-45).
b. Pull the shaft assembly out of the spool valve until
the shaft cap clears the valve body approximately 1/4".
CAUTION: Do not pull the shaft assembly out too
far or the spool valve may become cocked in the
valve body.
c. Carefully disengage the shaft pin from the valve spool
and remove the shaft assembly (fig. 3B-45).
Fig. 3 B-44—Installin g Retainer
B E A R IN G W IT H
ID E N T IF IC A T IO N
T O W A R D T O O L