Chevrolet 1977 10 Series, Руководство по ремонту, Страница: 227 / 468

ENGINE ELECTRICAL 6D-5
wire to insulated brush.
d. Repeat for other set of brushes.
2. Assemble overrunning clutch assembly to arm ature
shaft.
a. Lubricate drive end of arm ature shaft with silicone
lubricant.
b. Slide clutch assembly onto arm ature shaft with pinion
outward.
c. Slide retainer onto shaft with cupped suraface facing
end of shaft (away from pinion).
d. Stand arm ature on end of wood surface with
com m utator down. Position snap ring on upper end of shaft
and hold in place with block of wood. Tap wood block with
ham m er forcing snap ring over end of shaft (fig. 6D-9S). Slide
snap ring down into groove.
e. Assemble thrust collar on shaft with shoulder next to
snap ring.
Fig. 6D-9S--Forcing Snap Ring Over Shaft
Fig. 6 D - 10 S --F o rc in g S nap Ring In to R e ta in e r
f. Place arm ature flat on work bench, and position
retainer and th ru st collar next to snap ring. Then using two
pair of pliers at the same time (one pair on either side of
shaft), grip retainer and thrust collar and squeeze until snap
ring is forced into retainer (fig. 6D-10S).
3. Lubricate the drive housing bushing with a silicone
lubricant. M ake sure thrust collar is in place against snap ring
and retainer and slide arm ature and clutch assembly into
place in drive housing engaging shift lever with clutch.
4. Position field frame over arm ature and apply special
sealing com pound between frame and solenoid case. Position
frame against drive housing using care to prevent damage to
the brushes.
5. Lubricate the bushing in the com m utator end frame
with a silicone lubricant. Place leather brake washer on
arm ature shaft and slide com m utator end frame onto shaft.
6. Reconnect the field coil connectors to the "m otor"
solenoid terminal.
7. A fter overhaul is completed, perform "Pinion
Clearance Check".
P IN IO N C L E A R A N C E C H E C K
1. Connect a battery, of the same voltage as the solenoid,
from the solenoid switch term inal to the solenoid frame or
ground term inal (fig. 6D-11S).
N O TE: D isconnect the m otor field coil connector for
this test.
2. M om entarily flash a jum per lead from the solenoid
m otor term inal to the solenoid frame or ground terminal. The
pinion will now shift into cranking position and will remain
there until the battery is disconnected.
3. Push the pinion back towards the com m utator end to
eliminate slack movement.
4. M easure the distance between the pinion and pinion
stop (fig. 6D-12S). If clearance is not within specified limits
(.010-. 140) it may indicate excessive wear of solenoid linkage
shift lever yoke buttons or im proper assembly of the shift
lever mechanism. W orn or defective parts should be replaced.
SNAP
SNAP
G RO OVE