Chevrolet 1977 10 Series, Руководство по ремонту, Страница: 278 / 468

(20017A-42
OVERHAUL MANUAL
T.V. EXHAUST V A L V E LIFTER
THROTTLE LEVER &
BRACKET ASSEMBLY
THROTTLE LEVER
T O
CABLE LIN K
Fig. 7A-1 6 5 A —I nsta 11 i n g T h r o t t le V a lv e and B r a c k e t A s s e m b ly
Fig. 7A-1 6 6 A —I n sta 11 i ng Oil Screen
4. Install speedometer retainer and attaching bolt, align
slot in speedometer driven gear housing with retainer.
Torque bolt to 8.0-14.0 N -m (6-10 ft. lbs.).
5. Place transm ission in cradle or transmission jack.
Remove holding fixture, J-8763-02 from transmission.
PU M P
C O V E R
Fig. 7A-1 6 8 A - -R e m o v in g Pum p C over Bu s h in g - Front
BUSHING REPLACEMENT
PUMP COVER BUSHINGS
Front Bushing
1. Using tool J-24036 with Slide Ham m er, J-7004-1,
remove bushing (Fig. 7A-168A).
2. Using tool J-25019-2 with D river Handle J-8092,
drive or press new bushing into place until tool bottoms
(Fig. 7A-169A).
Rear Bushing
1. Using tool J-25019-14 with Slide H am m er J-7004-1,
remove bushing (Fig. 7A-170A).
2. Using tool J-25019-6 with D river Handle J-8092,
drive or press new bushing until tool bottom s (Fig. 7A-
171 A).
PUM P BODY BUSHING
1. Place pum p body with the m achined face down, on
two blocks of wood, to prevent dam aging the machined
surface.
2. Using tool J-25019-4 with Drive H andle J-8092,
remove bushing (Fig. 7A-172A).
3. Using tool J-25019-12 with D river H andle J-8092,
drive or press new bushing into place until tool bottom s
(Fig. 7A-173A).
Fig. 7A-1 67 A - -R e m o v in g and I n s ta ll in g Sper Driven Gear - Fig. 7A-1 6 9 A —I nsta 11 i ng Pum p C ove r B u s h in g - Fro n t
T y p ic a l
O I L S C R E E N
O" RING SEAL!
SPEEDOMETER DRIVEN
GEAR ASSEMBLY