Chevrolet 1977 10 Series, Руководство по ремонту, Страница: 252 / 468

(200)7A-16
OVERHAUL MANUAL
FEELER
GAGE
REAR CARRIER
Fig. 7 A - 6 3 A ~ C h e c k in g Rear C a rrie r Pin io n End Play
8. Inspect planet pinions for damage, rough bearings
or tilt.
9. Check pinion end play. Pinion end play should be
0.24-0.69mm (0.009"-0.027") (Fig. 7A-63A).
Reassembly
1. Install roller clutch to rear carrier thrust washer
(Fig. 7A-64A).
2. Install rollers that may have come out of roller clutch
cage, by compressing the energizing spring with forefinger
and inserting roller from outer edge (Fig. 7A-65A).
3. Install roller clutch assembly into roller clutch cam
(Fig. 7A-66A).
4. Install roller clutch race, spline side out and rotate
clutch race counterclockwise into position (Fig. 7A-67A).
5. Install 4 tanged rear carrier to rear internal gear
thrust washer. Align tangs into slots of rear carrier and
retain with petrolatum (Fig. 7A-68A).
6. Install roller clutch and rear carrier assembly into
rear internal gear (Fig. 7A-69A).
7. Install J-25013-1, open end first, into rear end of
case. Bolt J-25013-5 on end of case (Fig. 7A-70A).
8. T urn case to vertical position, pum p end up.
9. Install rear unit parts into case and into J-25013-1
sleeve (Fig. 7A-71A) indexing rear internal gear parking
pawl lugs to pass by parking pawl tooth.
10. Using J-25013-5 adjusting screw (Fig. 7A-70A) and
looking through parking pawl case slot, adjust the height
of the rear internal gear parking pawl lugs to align flush with
the parking pawl tooth.
THRUST WASHER
R E A R C A R R I E R
R O L L E R C L U T C H R E A R C A R R I E R
Fig. 7 A - 6 4 A - - ln s t a llin g T h r u s t W a s h e r Into Rear C a rrie r
Fig. 7 A - 6 6 A - l n s t a l l i n g Rolle r C lu tch Into Rear C a rrie r
R O L L E R C L U T C H R E A R C A R R I E R
R AC E
ENERGIZING
SPRING
Fig. 7 A -6 5 A -ln s ta ll in g Roller Into Cage
Fig. 7A-67A--lnstalling Roller Clutch Race