Using Help
|
Contents
|
Index
Back
120
Adobe Premiere Pro Help
Assembling a Sequence
Using Help
|
Contents
|
Index
Back
120
•
To set In and Out points in the sequence, click the Program view.
2
Do one of the following:
•
To mark an In point, go to the frame you want, and then click the Set In button .
•
To mark an Out point, go to the frame you want, and then click the Set Out button .
To set sequence In and Out points around a selection:
1
In the Timeline window, select a clip or gap in the sequence.
2
Choose Marker > Set Sequence Marker > In and Out Around Selection. This sets
sequence In and Out points that match the selection’s In and Out points.
This command is particularly useful when replacing or removing clips in the sequence
using three- and four- point editing methods. See
“Using Monitor controls to perform
three-point or four-point edits” on page 132
and
“Removing a clip or a range of frames
from the sequence” on page 147
.
To cue the current frame to an In or Out point:
Do one of the following:
•
To cue the current time to an In point, click the Go To In Point button .
•
To cue the current time to an Out point, click the Go To Out Point button .
Note:
To go to the beginning or end of clips in the sequence, use the Go To Next Edit button
and the Go To Previous Edit button . See
“Using Monitor window controls” on page 105
.
To move both the In and Out points without changing the duration:
In either view’s time ruler, or in the Timeline window’s time ruler, drag the textured area at
the center of the shaded span between the In and Out points. Make sure that you drag the
textured area; otherwise, you simply cue the current-time indicator.
To remove In and Out points in the Source or Program view:
1
Do one of the following:
•
To delete In or Out points from a clip, select the Source view.
•
To delete In or Out points from a sequence, select the Program view.
2
Depending on the type of marker you want to remove, choose Marker > Clear Clip
Marker or Marker > Clear Sequence Marker, and choose an option in the submenu:
•
In and Out resets both the In and Out point.
•
In resets the In point only.
•
Out resets the Out point only
By default, you can also clear an In or Out point by Alt-clicking the Set In button or
the Set Out button , respectively.
