YOKOGAWA CW140, User Manual, Page: 81 / 292

8-9
IM CW140-E
Instant Measure Mode
8
8.4 Logging in Instant Measure Mode
●
Viewing Logging Information
The CW140 shows the , and
marks in the upper-middle area of the display. It also shows information on
the start and end of logging in the lower section of the display. Information
shown on the display varies depending on whether the CW140 is ready for
logging, is performing logging or has finished logging, or how it starts or stops
logging.
If you want to show setup conditions (WIRING, V RANGE, A RANGE and
FREQUENCY SOURCE data items) in the logging information area (lower
section of the display), press the , or key. Pressing
the same key once again, or pressing the or
ESC
key returns to the
view of logging information.
●
Outputting Logged Data
This paragraph explains how to output data acquired during an interval from
the start to the end of logging. You can change/define settings related to data
output by pressing the (SETUP) key in the Instant Measure mode.
• Logging Setting
LOGGING: Select from the ON and OFF options.
• Condition Settings for Data Output (with "LOGGING" set to ON)
OUTPUT INTERVAL: Set a value between 2 minutes and 1000 hours, in
1-minute increments.
OUTPUT MEDIA: Select:
"MEMORY" to save in internal memory;
"FD" to save on a floppy disk; or
"PRINTER" to print.
FILENAME: Type the file name of data to be saved.
SAVE/PRINT ITEM: Select the data item to be saved or printed.
SEE ALSO
Section 8.5, "Setup Data Items of Instant Measure Mode," for details on the setup data items.
TIP
You are not allowed to set the time interval from the start to the end of logging at a value smaller than the
OUTPUT INTERVAL setpoint. If you set such a value, the CW140 shows an error message when you
press the key.